roombatch

Living room · Paint · warm minimal

Two-tone terracotta arch behind a reading chair

Paint the whole wall a soft sand, then paint a tall terracotta arch behind the chair. The arch gives the corner its own little room without a single new piece of furniture. It is cheap, reversible, and the most forgiving shape you can paint freehand-with-a-string.

Effort
Moderate
Time
1 day
Materials
$90–$170 in materials (illustrative)
Front elevation of Reading wall, 13′ wide by 8′ 6″ high, finished in paint.
Reading wall: 13′ wide × 8′ 6″ high · illustration, not a photograph

The palette

  • Wall
  • Support
  • Accent detail
  • Extra

Why it works

  1. An arch is a doorway your eye walks through. It frames the chair the way a niche frames a statue, so the corner reads as deliberate.
  2. Sand and terracotta share a warm red-yellow undertone, so the edge between them looks soft rather than stark, which hides a slightly wobbly curve.
  3. Running the arch down to the baseboard grounds it. A floating arch that stops short of the floor looks like a sticker.
  4. Keeping the arch about 1.5 times the chair's width leaves a margin of color on both sides, so the chair never looks squeezed.

How to build it

  1. Step 1

    Size the arch from the chair

    Measure the chair's width and add roughly 50 percent. A 30-inch chair gets a 44 to 46-inch arch. Make the straight sides reach about 6 feet 6 inches, then add the half-circle on top, so the peak lands near 7 feet 8 inches on an 8.5-foot wall. That leaves a band of sand above, which keeps the arch from feeling cramped against the ceiling.

  2. Step 2

    Paint the base color first

    Cut in and roll the whole wall in the sand color, two coats, and let it cure overnight. Painting the background first means the arch sits on top and any touch-up on the curve happens in only one color. Keep the leftover sand paint labelled; you will want it for crisping the curve later.

  3. Step 3

    Draw the curve with a string compass

    Find the arch's center line with a level. Tack a small nail at the spring point, where the straight sides end, and tie a pencil to a string the length of the radius. Swing the arc lightly. Tape the straight sides with low-tack tape and leave the curve untaped; flexible tape on a tight curve tends to pucker and bleed.

  4. Step 4

    Cut in the curve by hand

    Use a 2-inch angled sash brush with a short handle. Load a third of the bristle, rest your little finger on the wall, and pull the curve in short overlapping strokes. Fill the middle with a small foam roller. Do two coats, pulling the tape on the straight edges while the second coat is still wet.

  5. Step 5

    Clean up the edge

    Once dry, look at the curve from across the room, not from up close. Fix any bumps with the sand color and a fine artist's brush, nibbling the terracotta back to a smooth line. Re-hang nothing on the arch itself; a single wall lamp beside it does more than art inside it.

Shopping notes

  • One gallon of each color covers this wall; the arch uses about a quart, so buy terracotta in a quart if your store tints that size.
  • Choose matte or eggshell for both colors so the sheen matches. A satin arch on a matte wall will flash in raking light.
  • A 2-inch angled sash brush with a short handle beats a long-handled brush for curves.
  • Low-tack painter's tape rated for delicate surfaces, because the base coat is only a day old.

Avoid

  • Centering the arch on the wall instead of on the chair. The chair is the point.
  • Using a high-contrast pair like white and terracotta on your first arch; every wobble will show.
  • Taping the curve with stiff tape, which creases and lets paint creep underneath.

Questions people ask

Can I paint the arch without painting the whole wall?

Yes, if your existing wall color is warm and in good condition. Test terracotta against it on a sample board first; a cool gray base can make terracotta look muddy.

How wide should the arch be?

About 1.5 times the width of the furniture in front of it. For a 30-inch chair that is 44 to 46 inches.

Is it hard to repaint later?

No. Two coats of the base color will cover a mid-tone terracotta. Use a tinted primer first if you are going much lighter.

Read before you start