roombatch

Wall studio

Plan the wall, then buy it.

Sketch your wall to scale, put the doors and windows where they really are, and see seven finishes on it. The shopping list updates as you go, down to the last board.

  1. 1MeasureWall width and height, then drop in doors and windows where they really sit.
  2. 2Try finishesSeven finishes drawn on your actual wall, from flat paint to picture-frame boxes.
  3. 3Buy onceWhole cans, rolls and boards, with the layout maths shown so you can check it.

Wall A · 12′ × 8′ · Paint

Front elevation of Wall A, 12′ wide by 8′ high, finished in paint.

1 can of paint, about $52 in total.

Shopping list
ItemQuantityCost
Paint1 can × $52$52

Decimal feet: 8 ft 6 in is 8.5. Measure wall to wall at the widest point.

No doors or windows on Wall A. Add one, then drag it on the drawing to place it. Drag a corner to resize.

From the label

Two is honest

New drywall, patched spots or a big color change.

Screens lie a little. Paint a large sample board and look at it morning and night before you buy.

10%

10% covers most mistakes and a spare. Go 15% for busy patterns, many cuts or your first project.

Extras on the shopping list

Preset prices are illustrative placeholders. Put in what your store charges.

The numbers behind paint

Shopping list
ItemQuantityCost
Paint1 can × $52$52
Net surface
96 ft²
Coverage needed
211.2 ft²
Before rounding
0.60 cans

What this assumes

  • Openings are subtracted once, even where they overlap.
  • 2 coats at 350 ft² per container, plus 10% allowance.
  • Use the label's lower coverage figure for rough, porous or dark-to-light surfaces.
  • A planning estimate. Prices are illustrative; check the label and your supplier before ordering.

Same walls, seven ways

Compare every finish

Each card uses your measurements, openings, allowance and extras. Tap one to switch.

How the studio counts

Real layouts, not square-foot guesses

Most calculators multiply area by a price and stop. Materials aren't sold by the square foot, though. They come in cans, rolls, sheets and sticks, and the waste lives in how those pieces fit your wall.

Everything here is a planning estimate. Prices are illustrative placeholders you can change, and the product label always wins.

Paint and limewash count area

Openings come off once, even where a door and window overlap. Coats multiply the area, your allowance goes on top, and only then do we round up to whole containers. Rounding early is how people end up with a spare can on every wall.

Wallpaper counts drops

Every strip is hung full height, rounded up to a whole pattern repeat. Half-drop papers add half a repeat to alternate strips. Drops are then packed onto real roll lengths, which is why a window rarely saves you a roll.

Slats and battens are spaced evenly

You give a target gap or spacing; the studio solves for a whole number of boards that land on both ends of the wall and shows the true gap. Pieces are packed onto your board length, so offcuts are counted honestly.

Moulding is boxes and mitres

Box widths come from the wall width minus margins and gaps. With a chair rail, the lower row sits in the bottom third. Every box has four mitred sides packed onto stick lengths, so the cut list matches the drawing.

Just need one number?

Each finish has a focused calculator with a worked example and the mistakes worth avoiding.