On this page
- Key takeaways
- The four adhesive systems in one table
- Prepasted: water in, booking, then hang
- Paste the wall: the fastest route for most beginners
- Traditional paste-the-paper: slower, but forgiving
- Does paste type change how many rolls you need?
- Removal: where the paste choice pays you back
- Which should you choose for a first accent wall?
- Questions
Key takeaways
- Prepasted paper carries a dried adhesive that you activate with water, usually about a 30 second soak and a few minutes of booking.
- Paste-the-wall papers are typically non-woven: you roll adhesive onto the wall and hang the dry strip, with no soaking or booking.
- Traditional unpasted paper is pasted on the back and booked, often for around 10 minutes, so every strip relaxes the same amount.
- Paste type changes your tools and schedule, not your roll count: RoomBatch counts drops the same way for all of them.
- Follow the label over any general guide. Soak and booking times vary by product.
The four adhesive systems in one table
Wallpaper labels show the hanging method as a small symbol: a brush on the wall for paste-the-wall, a brush on the paper for paste-the-paper, a water tray or sponge for prepasted. Graham & Brown notes that its label symbols cover application method alongside match type and cleaning, so the answer is usually on the roll before you open it.
Here is what each method means in practice. The times are the manufacturer guidance quoted below, not a universal rule.
| System | How the adhesive gets there | Typical prep per strip | Tools you add |
|---|---|---|---|
| Prepasted | Dry adhesive on the backing, activated with water | Soak about 30 s, book about 5 min | Water tray, drop cloth, sponge |
| Unpasted, paste the paper | You brush paste onto the back of each strip | Paste, then book about 10 min | Pasting table, paste brush or roller, bucket |
| Paste the wall | You roll paste onto the wall, hang the strip dry | None for the paper | Roller and tray, paste, a brush for edges |
| Peel and stick | Pressure-sensitive adhesive under a liner | Peel liner as you go | Smoother, sharp blade, isopropyl wipe if the maker specifies |
Prepasted: water in, booking, then hang
Brewster describes prepasted paper as having a cured adhesive on the backing that is activated with water when it is booked. Its printed instructions spell out the routine: fill a water tray two thirds full with room-temperature water, roll the cut strip loosely pattern side in, submerge it for 30 seconds, lift it out onto the table, fold both ends to the middle paste side in without creasing, and let it rest for about 5 minutes.
That rest is called booking, and it is not optional. Paper-based wallcoverings absorb water and relax. If you hang one strip after two minutes and the next after eight, they can finish at slightly different widths, which shows up as gaps or bubbles at the seams. Consistency matters more than the exact number. Brewster's own prepasted guide notes that some of its lines need only 5 to 10 seconds in the tray, which is exactly why the label wins.
Paste the wall: the fastest route for most beginners
Paste-the-wall papers are usually non-woven, a fabric-like backing that does not expand much when wet. You roll adhesive directly onto the wall, a little wider than one strip, and offer up the dry paper. Graham & Brown says the method cuts installation time roughly in half because there is no soaking and no waiting.
The practical wins are bigger than speed. A dry strip is light and easy to slide into position against your plumb line. You can hang straight from the roll and trim at the ceiling, though you still need the same full drop length, so it does not save paper. And there is far less mess on the floor. Brewster recommends paste-the-wall for its unpasted papers unless the label says otherwise.
The catch: you only get one chance at even coverage. Missed patches show as bubbles or lifted edges a day later. Roll paste past the strip edge by an inch or two, and brush extra into corners and along the ceiling line where rollers skip.
Traditional paste-the-paper: slower, but forgiving
Unpasted papers that need adhesive on the back are the old way and still common for paper-based and specialty products. Brewster's instructions: lay the strip face down, paste the top half and fold it to the middle, paste the bottom half and fold it up, then rest the booked strip for about 10 minutes, checking the manufacturer's time.
This method gives you open time. A well-booked strip slides on the wall, so you can nudge it into a pattern match. It also asks the most of you: a pasting table, a clean bucket, a steady pace and spotless hands, because paste on the face of a delicate paper can mark it. Natural wallcoverings sit in this camp too. Wolf-Gordon's grasscloth guidance has paste rolled onto the back, a 3 minute rest, and a warning that paste and water on the face will stain the fibers.
- Mix powdered paste to the strength the label asks for; heavier papers need thicker paste.
- Keep the table edge clean between strips so you never transfer paste to a face.
- Paste and book only as many strips as you can hang within the window.
- Wipe surplus paste off ceilings and trim with a damp sponge as you go.
Does paste type change how many rolls you need?
No, and it is worth being clear about this. RoomBatch's wallpaper calculator counts strips the same way whatever the adhesive: strips equal wall width divided by roll width, rounded up; each drop is wall height plus 4 in of trim, rounded up to a whole pattern repeat for straight and half-drop papers; whole drops are packed into rolls with no splicing.
For a 12 ft by 8 ft wall using 20.5 in by 33 ft rolls with a 21 in straight repeat, that is 8 strips at 105 in each, three drops per roll, and one spare strip from a 10 percent allowance: 3 rolls. A 0.53 m by 10.05 m Euro roll needs 7 strips plus 1 spare, still 3 rolls. Whether you soak, paste the paper or paste the wall, those numbers hold.
What paste type does change is your shopping list and your first hour. Prepasted needs a tray. Paste-the-paper needs a table and more paste. Paste-the-wall needs a roller and enough adhesive for the wall area, which is the one place square footage genuinely matters.
| Example: 12 x 8 ft wall | US 20.5 in x 33 ft | Euro 0.53 x 10.05 m |
|---|---|---|
| Strips to hang | 8 | 7 |
| Drop length (21 in straight repeat) | 105 in / 8 ft 9 in | 105 in / 2.67 m |
| Drops per roll | 3 | 3 |
| Spare strips at 10% | 1 | 1 |
| Rolls, any adhesive system | 3 | 3 |
Removal: where the paste choice pays you back
Think about the end before the start. Graham & Brown says its paste-the-wall papers can be removed without wall damage and that most paste residue washes off with hot soapy water. Non-woven papers often strip dry in full lengths because the backing is stronger than the bond.
Prepasted and traditional paper-backed papers usually come off with water. Brewster explains that its adhesive is formulated to release when wet, and suggests scoring the paper and using a removal solution, which it finds generally works better than steaming. Brewster also recommends priming before you hang, partly so the next person can get it off.
Peel-and-stick sits outside this system entirely. It relies on low-tack adhesive and a compatible paint finish. Tempaper asks for smooth walls primed and painted in satin or semi-gloss, and Chasing Paper warns that matte paint can be damaged on removal.
Which should you choose for a first accent wall?
If you have a choice of the same design in more than one format, paste-the-wall non-woven is the easiest for most first-timers: dry strips, fast pattern matching, clean removal. Prepasted is a close second and the cheapest to set up, provided you stay disciplined about soak and booking times. Traditional paste-the-paper suits specialty papers and people who enjoy the craft. Peel-and-stick is the renter's tool, but it is the fussiest about the wall underneath it.
Whatever you choose, buy the adhesive the manufacturer names when it names one. Graham & Brown, for example, recommends a specific all-purpose wallpaper adhesive for its products rather than generic pre-mixed paste. The wrong paste is the most common cause of seams that lift a week later.
Questions people ask
Is prepasted wallpaper easier than paste-the-wall?
For most people paste-the-wall is easier, because the strip goes up dry and light with no soaking or booking. Prepasted is simple too, but you have to keep soak and booking times consistent or the seams can open as strips dry.
Can I put extra paste on prepasted wallpaper?
Some hangers add a thin activator or paste for stubborn edges, but check the label first. Extra adhesive can make removal harder and may not suit every backing. Edges usually lift because of short booking or dusty walls, not too little paste.
How long do you book wallpaper?
It depends on the product. Brewster's guidance is about 5 minutes for prepasted strips after a 30 second soak and about 10 minutes for unpasted paper pasted on the back. Paste-the-wall papers need no booking. Always use the time on your label.
Can paste-the-wall wallpaper go in a bathroom?
Graham & Brown says its paste-the-wall papers suit bathrooms when properly prepared and hung, but should not take direct water. Use a mildew-resistant adhesive if the maker allows it, and keep it away from the shower spray zone.
Does the type of paste change how much wallpaper to buy?
No. Roll count depends on wall width, height, roll size, repeat and match. The adhesive only changes how much paste and which tools you buy.
Terms in this guide
Sources & further reading
Planning information only. Product labels, manufacturer instructions and local codes take priority. Prices are illustrative. Read how we write and check guides in our editorial policy.