roombatch

Bathroom · Board & batten · heritage modern

Forest-green PVC board and batten in a family bathroom

Board and batten at 4.5 feet, built from PVC trim and painted a deep forest green. PVC shrugs off splashes and steam that would swell MDF, and the green with brass taps feels like an old club bathroom.

Effort
Moderate
Time
2 days
Materials
$180–$340 in materials (illustrative)
Front elevation of Vanity wall, 8′ wide by 8′ high, finished in board & batten.
Vanity wall: 8′ wide × 8′ high · illustration, not a photograph

The palette

  • Wall
  • Support
  • Accent detail
  • Extra

Why it works

  1. PVC is waterproof, so the lower wall, where splashes land, is protected.
  2. Forest green looks rich against white sanitaryware and brass.
  3. A 4.5-foot height clears a standard vanity backsplash and works with towel hooks above.
  4. 12-inch spacing on an 8-foot wall gives a tight, tailored rhythm.

How to build it

  1. Step 1

    Choose PVC and adhesive

    Use 1x4 PVC trim, 3.5 inches wide, for both rails and verticals. Fix it with a construction adhesive that lists PVC on the label, plus stainless or coated finish nails into studs. MDF swells and blisters around tubs and toilets within a year; PVC simply does not absorb water.

  2. Step 2

    Lay out around fixtures

    On an 8-foot wall, a 12-inch target spacing gives eight gaps and nine verticals at about 11.6-inch centers. Draw them on the wall and stand back. If one falls half-hidden behind the toilet tank or a supply pipe, shift the whole layout an inch or two rather than cutting that board short.

  3. Step 3

    Seal every joint

    Use a siliconized acrylic caulk that is paintable at every joint, along the top of the top rail and where the bottom rail meets the floor. That bottom joint matters most, because mop water and bath splashes collect there. Tool each bead smooth and let it cure fully before painting.

  4. Step 4

    Paint for humidity

    Scuff the PVC lightly with a fine abrasive pad and wipe it clean. Prime with a bonding primer, then paint with a mildew-resistant bathroom paint in satin, two coats. Run the exhaust fan and keep the shower off for a couple of days so the paint can harden properly.

Shopping notes

  • PVC 1x4 trim boards in 8-foot lengths.
  • Bonding primer that lists PVC on the label.
  • Bathroom or kitchen paint with mildew resistance in satin.
  • Siliconized acrylic caulk that is paintable.

Avoid

  • Using MDF in a full bathroom.
  • Painting PVC very dark where a window throws hot afternoon sun on it without checking the maker's color guidance; dark PVC can heat up and move.
  • Skipping the bonding primer on PVC.

Questions people ask

Can I paint PVC trim?

Yes, with a bonding primer and good acrylic paint. Scuff the surface first.

Will board and batten work behind a toilet?

Yes. Plan spacing so a vertical doesn't end up half-hidden behind the tank.

Do I need to waterproof the wall behind?

Outside wet zones, painted drywall behind PVC is fine. Inside showers, use proper tile or panels.

Read before you start