roombatch

Living room · Wall panels · warm contemporary

Fluted oak panels framing a TV

Cover the TV wall in vertical fluted oak-veneer panels, floor to ceiling. The ribs catch side light from the window, the warm wood makes the black screen look like part of the furniture, and the panels hide a cable chase.

Effort
Involved
Time
2 days
Materials
$700–$1,300 in materials (illustrative)
Front elevation of TV wall, 12′ wide by 8′ 6″ high, finished in wall panels.
TV wall: 12′ wide × 8′ 6″ high · illustration, not a photograph

The palette

  • Wall
  • Support
  • Accent detail
  • Extra

Why it works

  1. Vertical flutes add height to a standard 8.5-foot room.
  2. Warm wood frames a black screen better than a pale painted wall.
  3. Panels can be fixed to battens with a gap behind, giving a ready cable route.
  4. Natural texture is the opposite of a glossy screen, so the two balance.

How to build it

  1. Step 1

    Lay out from the TV, not the corner

    Center the panel layout on the TV, not the wall. With 2-foot-wide panels on a 12-foot wall, decide whether a panel center or a joint lines up with the screen; a panel center usually looks calmer. Any cut panels fall equally at both ends.

  2. Step 2

    Fit battens and route cables

    Screw horizontal 1x2 battens to the studs at 16 to 24 inches vertical spacing. Run the TV's power and cables in the batten gap to a low outlet box behind the console. Mount a steel TV bracket to studs or a backing board, not to the panels.

  3. Step 3

    Acclimatize and fix panels

    Leave panels in the room flat for 48 hours. Fix the first panel plumb with construction adhesive and pin nails into the battens, hiding nails in the flute grooves. Butt each panel tight to the last; check plumb every second panel.

  4. Step 4

    Cut around the TV bracket

    Mark the bracket's arms on the panel, cut slots with a jigsaw, and slide the panel over. Finish edges at the ceiling and the end walls with a matching scribe strip or a small shadow gap. Hang the TV last.

Shopping notes

  • On a 12 by 8.5-foot wall, 2 by 9-foot panels give one row with no horizontal joints: 6 panels plus one spare.
  • Check whether the veneer is pre-finished; raw veneer needs oil or lacquer before or after fitting.
  • Construction adhesive compatible with MDF-core panels.
  • A pin nailer and 1x2 battens or furring strips.

Avoid

  • Fixing the TV mount through the panels only.
  • Skipping acclimatization; panels can open at the joins as they settle.
  • Starting at a corner and ending with a sliver panel at the TV.

Questions people ask

Do I need battens?

Not always; panels can be glued straight to flat walls. Battens help on uneven walls and give space for cables.

Can I paint fluted panels later?

Yes, if they are MDF-core with a veneer. Lightly sand and prime first.

How tall should panels be?

Ideally the full wall height in one piece. A 9-foot panel avoids horizontal joints on a ceiling up to about 9 feet.

Read before you start